  |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
For robotics and other such applications where precise, repeatable positioning is paramount, our Axial Vane motors warrant your consideration. Available in both Servo and Industrial grades, they deliver these characteristics:
• Mechanically "Stiff" when Locked
• Smooth Starts and Slow Speed Operation
• Extremely Long Life -- Relatively Few Wearing Parts
• High Starting torque -- 97%
• Manifold Port Capability
A host of options are also available:
• Choice of Output Shafts
• Dual Relief Valves, Motor Mounted
• Rotor Shaft Extensions
• SAE B Flange Mount
• Tach Generator Packages
• Breaks, Rear Mounted
• Compatible Gear Boxes
HOW DO THEY WORK?
View a Cutaway Diagram
If your applicaiton involves contaiminant-laden environment, or if you require higher torqes than shown below, you should examine the data on our Rol-Seal® motors.
If you need technical or other data on Axial Vane motors that is not on this site; or if you would like our recommendations or any other assistance, please consider us at your service.
View or download a general overview of our Axial Vane Motors (14 page pdf)
For access to our Engineering Library, click here.
PERFORMANCE SPECIFICATIONS:
|
Model
No. |
Displacement In3/Rev |
Pressure ?? PSI |
Maximum RPM | Theoretical Torque (continuous) Pound Inches |
Weight Pounds |
||
| Continuous | Intermittent | Continuous | Intermittent | ||||
| 10 | 1.0 | 3000 | 3000 | 2000 (8.7 GPM) |
3000 (13 GPM) |
477 | 23 |
| 10A | 39 | ||||||
| 25 | 2.5 | 3000 | 3000 | 1500 (16.2 GPM) |
2000 (21.6 GPM) |
1194 | 39 |
| 35 | 3.5 | 3000 | 3000 | 1500 (22.7 GPM) |
2000 (30.3 GPM) |
1671 | 40 |
| 50 | 5.0 | 2500 | 3000 | 1500 (32.5 GPM) |
1500 (32.5 GPM) |
1990 | 46 |
| 70 | 7.0 | 2000 | 2000 | 1350 (40.9 GPM) |
1500 (45.5 GPM) |
2229 | 52 |
| Notes: | 1. Running torque approximately 94% of the theroetical. 2. Stall torque approximately 98% of the theroetical. 3. Volumetric efficiency up to 98% depending on speed and pressure. 4. Case drain line not to exceed 25 PSI (optional seals available for 250 PSI. 5. Intermittent conditions to be less than 10% of every minute. 6. Inlet and return pressures not to exceed the ratings listed above. 7. Model 10A is 1.0 in3 performance in 2.5 in3 from size. For maximum performance maintain a minimum of 500 PSI |
||||||
• Engineering Library • Custom Machining • Contact Von Ruden • Jobs •
VON RUDEN MANUFACTURING, INC
1008 FIRST ST N.E. | P.O. BOX 699 | BUFFALO, MN 55313
Phone: (763) 682-3122 | Fax: (763) 682-3954