Driven Tools, Live Tools, M-Spindles
…for Mazak
   …for Mori Seiki
…for Okuma
Simply stated, there are 4 fundamental reasons you should take a close look
at the driven tooling designed and built by Von Ruden:
• These live tools deliver greater precision over extended working lives
• They eliminate interference issues often encountered with other designs
• Changeovers are fast with your choice of
     ER Collet or Kennametal
® Quick Change interfaces as standards
• Optional 1500 PSI cooling lets you extend your feeds and speeds to their optimums

Greater Precision. Longer Lives. No Interference. How?
Unlike other driven tooling, all Von Ruden live tools are designed to extract maximum performance from specific machines. Since these M-spindles are machine-specific, each makes maximum use of that unit’s turret cone so it can have the largest possible diameter duplex bearings set around the clamping system.

The recessed spindle configurations common to all Von Ruden driven tools shorten the length of moment arm to yield longer bearing life -- while still maximizing tool length. And their superior ABEC /P4 (minimum) spindle bearings deliver outstanding rigidity over exceedingly long working lives.

Working life, strength and quiet operation are all also enhanced by unsurpassed gear quality. The hardened, honed right-angle spiral bevel and spur cut gears used in all our M-spindles are produced in-house to standards seldom met by others.

Currently, we offer this superior live tooling for the complete line of Mazak, Mori Seiki and Okuma units. Comprehensive descriptions and application data have been assembled in these three PDF documents:

VRM Mazak Live Tools (Rev. 10-08-B) PDF document
VRM Mori Seiki Rotory Tools (Rev. 10-08-C) PDF document
VRM Okuma Live tools (Rev. 10-08-C) PDF document

For personal attention to your specific Mazak, Mori Seiki or Okuma requirements,
give us a call at: 763.682.3122

or e-mail your questions to: sales@vonruden.com

Gearboxes Hydraulic Motors Overhung Load Adaptors Live Tooling
Engineering LibraryCustom Machining Contact Von Ruden Jobs

® Rol-Seal is a Registered Trademark of Von Ruden Manufacturing, Inc.

VON RUDEN MANUFACTURING, INC
1008 FIRST ST N.E.  |   P.O. BOX 699  |  BUFFALO, MN 55313
Phone:  (763) 682-3122   |    Fax:  (763) 682-3954